CROSSMEMBER And Cushion Rubber

WARNING: This page is about a different variant/trim than selected.

Install the transmission cushion rubber to the transmission, and tighten the bolt (A).
Install the transmission cushion rubber to the center crossmember, and temporarily tighten the nut (B).
Tightening torque:

Bolt (A)

35 N.m (3.6 kgf-m, 25.8 ft-lb)

Fig 1: Identifying Transmission Cushion Rubber, Center Crossmember Bolt And Nut
Courtesy of SUBARU OF AMERICA, INC.
Tighten the mounting bolts for front crossmember and rear crossmember.
Tighten the transmission cushion rubber mounting nut.
Tightening torque:

T1: 70 N.m (7.1 kgf-m, 51.6 ft-lb)

T2: 140 N.m (14.3 kgf-m, 103.3 ft-lb)

T3: 35 N.m (3.6 kgf-m, 25.8 ft-lb)

Fig 2: Identifying Front/Rear Crossmember Mounting Bolts
Courtesy of SUBARU OF AMERICA, INC.
Remove the transmission jack.
Install the center exhaust cover.
Tightening torque:

18 N.m (1.8 kgf-m, 13.3 ft-lb)
Install the center exhaust pipe (rear). <Ref. to INSTALLATION , Center Exhaust Pipe.>
Lower the vehicle.
Connect the battery ground terminal. <Ref. to BATTERY , NOTE, Note.>