LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2015 >> WRX Limited, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Manual Transaxle & Differential (TY75) (W/O STI)) >> Transfer Drive Gear >> Assembly

Transfer Drive Gear: Assembly

WARNING: This page is about a different variant/trim than selected.
  1. Install the needle bearing and snap ring to the transfer drive gear.
  2. Set the ST to the ball bearing inner race, then install the transfer drive gear.
    CAUTION: Do not apply a load in excess of 10 kN (1 ton, 1.1 US ton, 1.0 Imp ton).
    NOTE: Use a new ball bearing.

    ST 398177700 INSTALLER

    Fig 1: Installing Transfer Drive Gear
    G06652331Courtesy of SUBARU OF AMERICA, INC.
  3. Install the snap ring.
    Fig 2: Installing Snap Ring
    G06652329Courtesy of SUBARU OF AMERICA, INC.
  4. Inspect the clearance between the snap ring and the ball bearing. <Ref. to INSPECTION , Transfer Drive Gear.>
scientia non olet · About LEMON Manuals