LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2015 >> WRX Limited, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Manual Transaxle & Differential (TY75) (W/O STI)) >> Front Differential Assembly >> Installation

Front Differential Assembly: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the differential side retainers using ST.

    ST 18630AA010 WRENCH COMPL RETAINER

  2. Install the taper roller bearing outer race to the transmission case.
  3. Install the front differential assembly.
    CAUTION: Make sure the oil seal lip is not folded.
    Fig 1: Installing Front Differential Assembly
    G08318991Courtesy of SUBARU OF AMERICA, INC.
  4. Install the main shaft assembly. <Ref. to INSTALLATION , Main Shaft Assembly for Single-Range.>
  5. Install the drive pinion shaft assembly. <Ref. to INSTALLATION , Drive Pinion Shaft Assembly.>
  6. Install the transmission case. <Ref. to INSTALLATION , Transmission Case.>
  7. Install the transfer case together with the extension case assembly. <Ref. to INSTALLATION , Transfer Case and Extension Case Assembly.>
  8. Install the manual transmission assembly to the vehicle. <Ref. to INSTALLATION , Manual Transmission Assembly.>
scientia non olet · About LEMON Manuals