Transfer Driven Gear: Assembly

WARNING: This page is about a different variant/trim than selected.

Using the ST, install the taper roller bearing (transmission case side).
ST 499757002 INSTALLER
CAUTION:
- Do not apply pressure in excess of 10 kN (1 ton, 1.1 US ton, 1.0 Imp ton).
- Apply transmission gear oil onto sliding or revolving surfaces before installation.
NOTE: Be careful when handling because the taper roller bearing and the outer race are used as a set.

Fig 1: Installing Taper Roller Bearing (Transmission Case Side)
Courtesy of SUBARU OF AMERICA, INC.
Using the ST, install the taper roller bearing (extension case side).
ST1 398177700 INSTALLER

ST2 899864100 REMOVER
CAUTION:
- Do not apply pressure in excess of 10 kN (1 ton, 1.1 US ton, 1.0 Imp ton).
- Apply transmission gear oil onto sliding or revolving surfaces before installation.
NOTE: Be careful when handling because the taper roller bearing and the outer race are used as a set.

Fig 2: Installing Taper Roller Bearing (Extension Case Side)
Courtesy of SUBARU OF AMERICA, INC.