LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2015 >> WRX Limited, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Manual Transaxle & Differential (TY85) (STI)) >> Shifter Fork and Rod >> Assembly >> Striking Rod

Striking Rod

WARNING: This page is about a different variant/trim than selected.
  1. Using the ST, install the reverse interlock arm and interlock arm.

    ST 398791700 REMOVER

    NOTE:
    • Confirm that the reverse interlock arm and rod are installed in the proper direction.
    • Confirm that the interlock arm and rod are installed in the proper direction.
    • Use a new straight pin.
    Fig 1: Installing Reverse Interlock Arm And Interlock Arm
    G10269246Courtesy of SUBARU OF AMERICA, INC.
  2. Attach the reverse interlock block and interlock block to the striking rod.
    NOTE: Confirm that the reverse interlock block and interlock block are installed in the proper direction.
    Fig 2: Attaching Reverse Interlock Block And Interlock Block To Striking Rod
    G10269247Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals