Reverse Check System: Inspection

WARNING: This page is about a different variant/trim than selected.

Check that there is no damage on any parts.
Check that the reverse check lever is operating smoothly.
Inspect that there is no oil leak at the oil seal section of the reverse check shaft. If there is oil leakage, replace the oil seal.
Check the operation of the reverse check.
1. When the reverse check lever is in the following position, the plunger is pressed, or the gear can shift into reverse.
  
  Fig 1: Checking Reverse Check Lever
  Courtesy of SUBARU OF AMERICA, INC.
2. When the reverse check lever is in the following position, the plunger is not pressed, or the gear cannot shift into reverse.
Fig 2: Identifying Reverse Check Lever
Courtesy of SUBARU OF AMERICA, INC.
If it is not as specified, reassemble the reverse check system.