Differential Case

WARNING: This page is about a different variant/trim than selected.

Using the ST, attach the RH and LH taper roller bearing inner races to the differential case.
ST1 398437700 INSTALLER

ST2 398497701 SEAT

CAUTION: Do not apply pressure in excess of 20 kN (2.0 ton, 2.2 US ton, 2.0 Imp ton).

NOTE: Always replace the taper roller bearing inner race and outer race as a set.

Fig 1: Attaching RH And LH Taper Roller Bearing Inner Races To Differential Case
Courtesy of SUBARU OF AMERICA, INC.
Install the hypoid driven gear to differential case.
ST 18270KA020 SOCKET (E20)

Tightening torque:

69 N.m (7.0 kgf-m, 50.9 ft-lb)