LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2015 >> WRX Limited, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Manual Transaxle & Differential (TY85) (STI)) >> Back-up Light Switch >> Installation

Back-up Light Switch: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the back-up light switch.
    NOTE: Use a new gasket.

    Tightening torque: 

    32 N.m (3.3 kgf-m, 23.6 ft-lb) 

  2. Connect the back-up light switch connector.
  3. Install the manual transmission assembly to the vehicle. <Ref. to INSTALLATION , Manual Transmission Assembly.>
scientia non olet · About LEMON Manuals