LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2015 >> WRX Limited, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Exhaust System (STI)) >> Joint Pipe >> Removal

Joint Pipe: Removal

WARNING: This page is about a different variant/trim than selected.
CAUTION: Vehicle components are extremely hot after driving. Be wary of receiving burns from heated parts.
  1. Disconnect the ground cable from battery.
  2. Lift up the vehicle.
  3. Remove the under cover. <Ref. to REMOVAL , Front Under Cover.>
  4. Remove the front oxygen (A/F) sensor. <Ref. to REMOVAL , Front Oxygen (A/F) Sensor.>
  5. Remove the exhaust manifold RH lower cover.
    Fig 1: Locating Exhaust Manifold RH Lower Cover Bolts
    G05661023Courtesy of SUBARU OF AMERICA, INC.
  6. Remove the bolts and nuts which hold exhaust manifold RH onto joint pipe.
    Fig 2: Locating Exhaust Manifold RH Bolts And Nuts
    G04998841Courtesy of SUBARU OF AMERICA, INC.
  7. Remove the center exhaust pipe. <Ref. to REMOVAL , Center Exhaust Pipe.>
  8. Remove the turbocharger. <Ref. to REMOVAL , Turbocharger.>
  9. Take off the joint pipe in the upward direction.
scientia non olet · About LEMON Manuals