Radiator Sub Fan and Fan Motor: Removal

WARNING: This page is about a different variant/trim than selected.

Disconnect the ground cable from battery.
Lift up the vehicle.
Remove the under cover. <Ref. to REMOVAL , Front Under Cover.>
Disconnect the connector from the sub fan motor.

Fig 1: Locating Sub Fan Motor Connector
Courtesy of SUBARU OF AMERICA, INC.
Lower the vehicle.
Remove the air intake duct. <Ref. to REMOVAL , Air Intake Duct.>
Remove the bolts which secure the radiator sub fan motor assembly and the over flow pipe.

Fig 2: Locating Radiator Sub Fan Motor Assembly Bolts
Courtesy of SUBARU OF AMERICA, INC.
Raise the radiator sub fan motor assembly slightly, remove the pin at the lower part of the radiator sub fan motor assembly from the radiator hole, and remove the radiator sub fan motor assembly from the lower side of the vehicle.