LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2015 >> WRX Limited, Automatic CVT Trans >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> Engine Intake System (Induction) And Turbocharger (Except STI) >> Intake Duct >> Assembly >> Intake Duct No. 1

Intake Duct No. 1

Install the vacuum hose and wastegate control solenoid valve to the intake duct No. 1.

NOTE:
  • Use new O-rings.
  • When tightening the boost control solenoid valve, check that it is securely seated.

Tightening torque: 

2.8 N.m (0.3 kgf-m, 2.1 ft-lb) 

Fig 1: Locating Vacuum Hose And Wastegate Control Solenoid Valve With Screws
G09480096Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals