Mid Switch
- Measure the resistance between connector terminals.
Preparation tool:
Circuit tester
Courtesy of SUBARU OF AMERICA, INC.
Terminal No. Inspection conditions Standard 3 - 2 up triangle (UP) i/SET down triangle(DOWN) All OFF Approx. 1 MΩ or more 3 - 2 up triangle (UP) ON Less than 1 Ω 3 - 2 i/SET ON Approx. 1000 Ω 3 - 2 down triangle (DOWN) ON Approx. 3700 Ω - Apply battery voltage between the connector terminals to check lighting condition of illumination inside the switch.
Terminal No. Inspection conditions Specification 4 (+) - 1 (-) Apply battery voltage. Light ON - Replace the MID switch if the inspection result is not within the standard value.