Meter pointer indication check

In meter pointer indication check, the meter operation, warning/indicator light and fuel level warning light are checked.

NOTE: ILL indication illuminates at the same brightness as immediately before entering "Meter pointer indication check".

After a buzzer sounds for 0.5 seconds and "STEP2" is displayed on TFT, the meter pointer indication check mode is initiated.

Time (sec)

Speedometer (km/h)

Tachometer (r/min)

Fuel gauge

Engine coolant temperature gauge

Fuel level warning light

Warning/indicator light

1.5

Lowest point

Light ON

⁽¹⁾, ⁽²⁾

1.5

1000

Light ON

1.5

100

4000

1/2

Starting point of the red line

Light OFF

1.5

140

8000

Light OFF

1.5

100

4000

1/2

Starting point of the red line

Light OFF

1.5

1000

Light ON

⁽¹⁾	Warning lights and indicator lights controlled by the meter drive circuit go off. <Ref. to SPECIFICATION , General Description.>

⁽²⁾	Warning lights and indicator lights controlled by other module are turned on/off according to the module control. <Ref. to SPECIFICATION , General Description.>