Trip Reset Switch

Disconnect the ground terminal from battery sensor. <Ref. to BATTERY , NOTE, Repair Contents.>
Remove the cover assembly - instrument panel LWR driver. <Ref. to REMOVAL , Instrument Panel Lower Cover.>
Remove the visor assembly - lower.
1. Release the clips and claws.
2. Disconnect the connector and remove the visor assembly - lower.
  CAUTION: Be careful not to damage the clips and claws by slowly removing the right and left edges of visor assembly - lower.
  
  Fig 1: Identifying Combination Meter Clips And Claws
  Courtesy of SUBARU OF AMERICA, INC.
Release the claws, and remove the switch assembly - trip reset.

Fig 2: Removing Switch Assembly - Trip Reset
Courtesy of SUBARU OF AMERICA, INC.