DTC B1507 External Air Temperature Open/Short-Circuit Detection: Wiring Diagram

NOTE: For the coupling connector, refer to "WIRING SYSTEM".
Air conditioning system <Ref. to AIR CONDITIONING (Legacy), AIR CONDITIONING (Outback).>

Fig 1: Ambient Sensor Wiring Diagram

G10272794

Courtesy of SUBARU OF AMERICA, INC.

DIAGNOSTICS PROCEDURE

Step	Check	Yes	No
1 CHECK DTC. Read the DTC of the meter using the Subaru Select Monitor. <Ref. to READ DIAGNOSTIC TROUBLE CODE (DTC) .>	Is DTC B1507 a current malfunction?	Go to step 2.	Go to step 6.
2 CHECK CURRENT DATA. Using the Subaru Select Monitor, display the «External air temperature sensing value» from «Current Data Display & Save».	Is data displayed?	Even if DTC is displayed, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again. NOTE: In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.	Go to step 3.
3 CHECK HARNESS. Turn the ignition switch to OFF. Disconnect the meter connector and ambient sensor connector. Using the tester, measure the resistance between terminals. Connector & terminal (i10) No. 23 - (B480) No. 2: (i10) No. 24 - (B480) No. 1:	Is the resistance 10 Ω or less?	Go to step 4.	Repair the open circuit of harness or replace harness.
4 CHECK HARNESS. Using the tester, measure the resistance between terminals. Connector & terminal (i10) No. 23 - Chassis ground: (i10) No. 24 - Chassis ground:	Is the resistance 10 Ω or less?	Repair the short circuit of harness or replace harness.	Go to step 5.
5 CHECK AMBIENT SENSOR. Perform the inspection of ambient sensor unit. <Ref. to INSPECTION , Ambient Sensor.>	Is the sensor normal?	Go to step 6.	Replace the sensor.
6 CHECK CONNECTOR. Turn the ignition switch to OFF. Disconnect connectors.	Is there poor contact of connector?	Repair or replace the poor contact of connector.	Even if DTC is displayed, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again. NOTE: In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.