Transmission Valve Body ASSY: Installation

WARNING: This page is about a different variant/trim than selected.

Installation of transmission valve body ASSY
1. Insert the spring and the check ball body into the transmission case.
2. Make sure that the accumulator piston, spring, and check ball body are installed to the transmission case.
  
  Fig 1: Identifying Check Ball Body And Accumulator Piston
  Courtesy of SUBARU OF AMERICA, INC.
  
  NOTE: If the accumulator piston, spring, and check ball body come off, apply auto fluid WS and install them.
3. Connect the lever pin to the manual valve hole.
  
  Fig 2: Identifying Lever Pin And Manual Valve
  Courtesy of SUBARU OF AMERICA, INC.
4. Install the transmission valve body ASSY with 19 bolts.
  Standard value: T=11N.m {112kgf.cm} {8.1ft.lbf}
  NOTE:
  Bolt under head length:
  - 25 mm {0.984 in} (Bolt A)
  - 36 mm {1.417 in} (Bolt B)
  - 45 mm {1.772 in} (Bolt C)
  - 50 mm {1.969 in} (Bolt D)
5. Install the detent spring and detent spring cover with a bolt.
  Standard value: T=10N.m {102kgf.cm} {7.4ft.lbf}
Transmission wire connection (refer to UNIT INSPECTION )
Installation of valve body oil strainer ASSY (refer to INSTALLATION )
Installation of transmission oil pan SUB-ASSY (ATM) (refer to INSTALLATION )
Installation of exhaust pipe SUB-ASSY FR (refer to INSTALLATION )
Connection of battery ground terminal (refer to INSTALLATION )
Fill of automatic transmission fluid (refer to ADJUSTMENT )

Fig 3: Identifying Transmission Valve Body Assy Bolts
Courtesy of SUBARU OF AMERICA, INC.