Neutral Start Switch ASSY: Adjustment

WARNING: This page is about a different variant/trim than selected.

Adjustment of neutral start switch ASSY
1. Set the select lever to N position.
2. Loosen the set bolt on the neutral start switch ASSY.
  
  Fig 1: Identifying Set Bolt, Neutral Reference Line And Kerf
  Courtesy of SUBARU OF AMERICA, INC.
3. Move the neutral start switch ASSY to align the neutral reference line and the kerf.
4. Tighten the set bolt.
  Standard value: T=13N.m {130kgf.cm} {9.6ft.lbf}
5. After the adjustment, check the neutral start switch ASSY. (Refer to ADJUSTMENT )