LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2014 >> BRZ Premium >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transaxle (Diagnostics)) >> Automatic Transmission System >> DTC P0973 Shift Solenoid "A" Control Circuit Low; DTC P0974 Shift Solenoid "A" Control Circuit High >> Inspection steps

Inspection steps

WARNING: This page is about a different variant/trim than selected.
ON/OFF STATUS WHEN TRANSMISSION 3 WAY SOLENOID ASSY (S1) IS NORMAL (SELECT LEVER IN D POSITION)

Gear position 1st 2nd 3rd 4th 5th 6th
Transmission 3 way solenoid ASSY (S1) OFF ON ON ON ON ON
  1. Check of transmission 3 way solenoid ASSY (S1) system
    1. Disconnect the connector A18 of the transmission control computer ASSY.
    2. Measure the voltage between the terminals. (Refer to ECM TERMINAL ARRANGEMENT  for terminal arrangement of transmission control computer ASSY)
      VOLTAGE

      Inspection terminals Inspection conditions Standard value
      A18-7 (S1) - chassis ground IG ON Less than 1 V
    3. Measure the resistance between the terminals. (Refer to ECM TERMINAL ARRANGEMENT  for terminal arrangement of transmission control computer ASSY)
      RESISTANCE

      Inspection terminals Inspection conditions Standard value
      A18-7 (S1) - chassis ground 20°C 11 to 15 Ω
    4. Connect the connector A18 of the transmission control computer ASSY.

      NG: Step  4

      OK: Go to Next Step

  2. Check wiring harness and connector (transmission wire - transmission control computer ASSY)
    1. Disconnect the connector A18 of the transmission control computer ASSY.
    2. Disconnect the connector L4 of the transmission control wire.
    3. Measure the voltage between the terminals.
      VOLTAGE

      Inspection terminals Inspection conditions Standard value
      L4-1 (S1) - chassis ground IG ON Less than 1 V
    4. Measure the resistance between the terminals.
      RESISTANCE

      Inspection terminals Inspection conditions Standard value
      L4-1 (S1) - A18-7 (S1) Always Less than 1 Ω
      L4-1 (S1) and A18-7 (S1) - chassis ground Always 10 k Ωor more
    5. Connect the connector L4 of the transmission wire.
    6. Connect the connector A18 of the transmission control computer ASSY.

      NG: Repair or replacement of wiring harness or connector

      OK: Go to Next Step

  3. Replacement of transmission control computer ASSY
    1. Replace the transmission control computer ASSY. (Refer to TRANSMISSION CONTROL COMPUTER ASSY )

      Next: AT unit correction (refer to WORK SUPPORT  )

  4. Check of transmission 3 way solenoid ASSY (S1) unit
    1. Remove the transmission 3 way solenoid ASSY (S1). (Refer to DISASSEMBLY )
    2. Check the transmission 3 way solenoid ASSY (S1) unit. (Refer to NEUTRAL START SWITCH ASSY )

      NG: Replacement of the transmission 3 way solenoid ASSY (S1) (Refer to DISASSEMBLY )

      OK: Repair or replacement of transmission wire (refer to TRANSMISSION WIRE )

scientia non olet · About LEMON Manuals