Power Supply Outlet Socket (Installed To The Front Side): Removal

Removal of glove compartment door. (Refer to DISASSEMBLY )
Removal of power supply outlet socket assembly NO. 2
1. While pressing the inner claw of power supply outlet socket assembly NO. 2 with a flat tip screwdriver wrapped with protective tape, pull the assembly toward you.
  
  Fig 1: Removing Power Supply Outlet Socket Assembly No. 2
  Courtesy of SUBARU OF AMERICA, INC.
2. Disconnect the connector and remove power supply outlet socket assembly NO. 2.
  NOTE: If it is difficult to remove the assembly, remove the instrument panel sub-assembly LWR and release the claw from behind.
Removal of clip
1. Release the 2 claws and remove the clip.
  
  Fig 2: Removing Clip And Claws
  Courtesy of SUBARU OF AMERICA, INC.