LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Outback Base, Automatic CVT Trans >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical (H4DO) >> Crank Pulley >> Removal

Crank Pulley: Removal

NOTE: When replacing a single part, perform the work with the engine assembly installed to body.
  1. Remove the V-belts. Refer to REMOVAL .
  2. Use the ST to lock the crank pulley, and remove the crank pulley bolt.
    NOTE: To prevent damaging ST1, attach the ST2 onto the ST1 as shown.

    ST1 18355AA000 PULLEY WRENCH

    ST2 18334AA000 PULLEY WRENCH PIN SET

    Fig 1: Removing Crank Pulley Bolt
    G08316897Courtesy of SUBARU OF AMERICA, INC.

    ST1 18355AA000 PULLEY WRENCH

    ST2 18334AA000 PULLEY WRENCH PIN SET

    Fig 2: Tightening Crank Pulley Bolt Using Tool
    G08580066Courtesy of SUBARU OF AMERICA, INC.
  3. Remove the crank pulley and remove the crank pulley boss.
    Fig 3: Locating Crank Pulley Boss
    G08580067Courtesy of SUBARU OF AMERICA, INC.
  4. Remove the front oil seal.
    Fig 4: Locating Front Oil Seal
    G08580068Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals