DTC P0716 Torque Converter Turbine Speed: Wiring Diagram

CVT Control System. See appropriate SYSTEM WIRING DIAGRAM article.

Fig 1: CVT Control System - Wiring Diagram (Torque Converter Turbine)

G08579096

Courtesy of SUBARU OF AMERICA, INC.

DIAGNOSTIC PROCEDURE

Step	Check	Yes	No
1 CHECK FUSE. Turn the ignition switch to OFF. Remove the M/B fuse (No. 38).	Is the fuse OK?	Go to step 2 .	Replace the fuse. If the fuse blows out easily, repair the short circuit of harness.
2 CHECK HARNESS. Turn the ignition switch to OFF. Disconnect the TCM and transmission connectors. Measure the resistance between TCM connector and transmission connectors. Connector & terminal (B54) No. 1 - (B12) No. 7: (B54) No. 20 - (B12) No. 9: (M/B No. 38) No. 2 - (B12) No. 6:	Is the resistance less than 1 Ω?	Go to step 3 .	Repair the open circuit of harness.
3 CHECK HARNESS. Measure the resistance between TCM connector and chassis ground. Connector & terminal (B54) No. 20 - Chassis ground:	Is the resistance 1 MΩ or more?	Go to step 4 .	Repair the short circuit of harness.
4 CHECK TRANSMISSION HARNESS. Connect the TCM connector. Turn the ignition switch to ON. Measure the voltage between transmission connector terminals. Connector & terminal (B12) No. 6 (+) - (B12) No. 7 (-):	Is the voltage 10 - 13 V?	Go to step 5 .	Repair the open circuit of harness or poor contact of connector.
5 CHECK INPUT SIGNAL FOR TCM. Turn the ignition switch to OFF. Connect the transmission connector. Start the engine. Read the data of «Turbine Revolution Speed» using the Subaru Select Monitor.	Does the value of «Turbine Revolution Speed» change according to the engine speed?	Current condition is normal. Repair the poor contacts of harnesses of turbine speed sensor and transmission connector.	Go to step 6 .
6 CHECK TRANSMISSION HARNESS. Turn the ignition switch to OFF. Disconnect the transmission connector. Lift up the vehicle. Disconnect the turbine speed sensor connector. Measure the resistance between transmission connector and turbine speed sensor connector. Connector & terminal (T3) No. 6 - (AT5) No. 1: (T3) No. 7 - (AT5) No. 3: (T3) No. 9 - (AT5) No. 2:	Is the resistance less than 1 Ω?	Replace the turbine speed sensor. Refer to TURBINE SPEED SENSOR .	Replace the transmission harness.