Center Belt RH Assembly & LH Assembly

Disconnect the ground cable from battery and wait for at least 60 seconds before starting work.
CAUTION: The airbag system is fitted with a backup power supply. After disconnecting the battery ground cable, the airbag may operate if you do not wait for 60 seconds before starting the service of airbag system.
Remove the rear seat cushion.
1. Pull up the seat cushion and release the hook.
  CAUTION: If the hook is disconnected from the vehicle body, replace the hook with the new part to prevent the decline of the fixed force of the seat.
  
  Fig 1: Identifying Rear Seat Cushion
  Courtesy of SUBARU OF AMERICA, INC.
  
  Fig 2: Pulling Up To Seat Cushion
  Courtesy of SUBARU OF AMERICA, INC.
2. Remove the hook (A) by pushing it back while lifting the front side of the seat cushion, and remove the seat cushion.
  
  Fig 3: Removing Seat Cushion
  Courtesy of SUBARU OF AMERICA, INC.
Remove the center belt RH assembly & LH assembly.
1. Remove the bolts and remove the ISO-FIX anchor.
2. Remove the bolts, then remove the center belt RH assembly & LH assembly.
  - Sedan model
    
    Fig 4: Locating Center Belt RH Assembly & LH Assembly Mounting Bolts (Sedan Model)
    Courtesy of SUBARU OF AMERICA, INC.
  - OUTBACK model
    
    Fig 5: Locating Center Belt RH Assembly & LH Assembly Mounting Bolts (Outback Model)
    Courtesy of SUBARU OF AMERICA, INC.