Shoulder Belt Ctr Assembly (Sedan Model)

CAUTION: If the hook is removed from vehicle body, replace the hook with the new part to avoid the deterioration of seat securing.

Fig 1: Identifying Rear Seat Cushion

Courtesy of SUBARU OF AMERICA, INC.

Install the shoulder belt retractor.
Tightening torque:

REAR SEAT BELT (SEDAN MODEL): < Refer to REAR SEAT BELT (SEDAN MODEL) , COMPONENT, General Description. >
Install the rear shelf trim.
Install the shoulder belt lower anchor.
CAUTION:
- During installation, make sure that the seat belts are not twisted.
- After installation, make sure that the seat belts are smoothly extended and wound.
Tightening torque:

REAR SEAT BELT (SEDAN MODEL): < Refer to REAR SEAT BELT (SEDAN MODEL) , COMPONENT, General Description. >
Rear quarter upper trim
Install the remaining parts in the reverse order of removal.
After installation, check the following points.
- The seat belt is not twisted.
- The seat belt can be pulled out and retracted smoothly.