Center Belt Assembly RH & LH

Install the center belt assembly.
Tightening torque:

REAR SEAT BELT (SEDAN MODEL): < Refer to REAR SEAT BELT (SEDAN MODEL) , COMPONENT, General Description. >

Rear seat belt (OUTBACK model): < Refer to REAR SEAT BELT (OUTBACK MODEL) , COMPONENT, General Description. >
Install the ISO-FIX anchor.
Tightening torque:

25 N.m (2.55 kgf-m, 18.4 ft-lb)
Install the rear seat cushion.
CAUTION: If the hook is disconnected from the vehicle body, replace the hook with the new part to prevent the decline of the fixed force of the seat.

Fig 1: Identifying Rear Seat Cushion
Courtesy of SUBARU OF AMERICA, INC.
Install the remaining parts in the reverse order of removal.
After installation, check the following points.
- The seat belt is not twisted.
- Check that the airbag warning light lights up for approximately 6 seconds and then turns off when connecting the battery ground cable and turning the ignition switch to ON.