LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Legacy Premium, Automatic CVT Trans >> Repair and Diagnosis >> Maintenance >> Schedule >> General Information >> Periodic Maintenance Services >> Suspension >> Inspection >> Rear Suspension Ball Joint

Rear Suspension Ball Joint

  1. Lift up the vehicle until rear wheels are off ground.
  2. Grasp the bottom of tire and move it in and out in axial direction.
  3. If movement is observed between the brake disc cover (A) and end of front lateral link (B), ball joint may be excessively worn.
    Fig 1: Identifying Brake Disc Cover And End Of Front Lateral Link
    G06648220Courtesy of SUBARU OF AMERICA, INC.
  4. Grasp the end of front lateral link (B) and move it up and down. If movement is observed between the housing (C) and front lateral link (B) boss, ball joint may be excessively worn.
    Fig 2: Identifying Front Lateral Link And Housing
    G06648221Courtesy of SUBARU OF AMERICA, INC.
  5. If the movement related to the previous two steps is observed, replace the front lateral link. Refer to FRONT LATERAL LINK .
  6. Damage of dust boot

    Visually inspect the ball joint dust boot. Replace if front lateral link is damaged.

  7. Check upper arm ball joint in the same manner.
    Fig 3: Identifying Upper Arm Ball Joint
    G08579580Courtesy of SUBARU OF AMERICA, INC.