LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Legacy Premium, Automatic CVT Trans >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> HVAC System (Heater, Ventilator And A/C) >> Sunload Sensor (Auto A/C Model) >> Removal

Sunload Sensor (Auto A/C Model): Removal

NOTE: The sunload sensor is integrated with the light control sensor.
  1. Disconnect the ground cable from battery.
  2. Remove the sunload sensor.
    CAUTION: Be careful not to damage the sensors and interior trims when removing.
    1. Release the claws and clips, then detach the side speaker cover (RH).
      Fig 1: Identifying Side Speaker Cover Claws And Clips
      G06653427Courtesy of SUBARU OF AMERICA, INC.
    2. Push out the sunload sensor by pressing the left and right claws.
    3. Disconnect the connector and remove the sunload sensor.
      Fig 2: Disconnecting Sunload Sensor Connector
      G06653428Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals