Check Actuator Operation

Preparation tool: Circuit tester 

1. Check the actuator operation when battery voltage is applied between the terminals of rear vent actuator.
   CAUTION: Disconnect the battery immediately after the actuator stops operation. Otherwise, the motor may be damaged.

   Terminal No.	Inspection conditions	Operating position	Connection diagram
   6 (+) - 7 (-)	Connect battery to the terminals	COOL
   7 (+) - 6 (-)		HOT

2. Check the resistance between terminals of rear vent actuator.

   Terminal No.	Inspection conditions	Standard	Connection diagram
   1 - 3	Always	4.2 - 7.8 Ω

3. Connect the rear vent actuator connector, turn the ignition switch to ON and check the voltage between terminals of rear vent actuator.

   Terminal No.	Inspection conditions	Standard	Connection diagram
   5 (+) - 3 (-)	HOT	Approx. 1.0 V
   	COOL	Approx. 4.0 V

4. Replace the rear vent actuator if it is found defective.