Check Actuator Operation

Preparation tool: 

Circuit tester 

1. Check the actuator operation when battery voltage is applied between the terminals of mode door actuator.
   CAUTION: Disconnect the battery immediately after the actuator stops operation. Otherwise, the motor may be damaged.

   Terminal No.	Inspection conditions	Operating position	Connection diagram
   4 (+) - 5 (-)	Connect battery to the terminals	FACE
   5 (+) - 4 (-)		DEF

2. Check the resistance between terminals of the mode door actuator.

   Terminal No.	Inspection conditions	Standard	Connection diagram
   1 - 2	Always	4.2 - 7.8 Ω

3. Connect the mode door actuator connector, turn the ignition switch to ON and check the voltage between terminals of the mode door actuator.

   Terminal No.	Inspection conditions	Standard	Connection diagram
   3 (+) - 2 (-)	FACE	Approx. 4.0 V
   	DEF	Approx. 1.0 V

4. Replace the mode door actuator if it is found defective.