Blower Switch (Manual A/C Model)

Preparation tool: Circuit tester 

1. Check the resistance between terminals of the control panel.

   Terminal No.	Inspection conditions	Standard	Connection diagram
   -	OFF	-	-
   1 - 2, 4	1 (LO)	Less than 1 Ω
   1 - 3, 4	2 (M1)	Less than 1 Ω
   1 - 4, 6	3 (M2)	Less than 1 Ω
   1 - 4, 5	4 (HI)	Less than 1 Ω

2. Replace the control panel if the inspection result is not within the standard value.