CROSSMEMBER And Cushion Rubber

WARNING: This page is about a different variant/trim than selected.

Install the transmission cushion rubber to the transmission, and tighten the bolt (A).
Attach the transmission cushion rubber to the center crossmember, and tighten nut (B).
Tightening torque:

Bolt (A)

35 N.m (3.6 kgf-m, 25.8 ft-lb)

Nut (B)

35 N.m (3.6 kgf-m, 25.8 ft-lb)

Fig 1: Identifying Transmission Cushion Rubber Mounting Nuts And Bolts
Courtesy of SUBARU OF AMERICA, INC.
Install the front crossmember and rear crossmember.
Tightening torque:

T1: 75 N.m (7.6 kgf-m, 55.3 ft-lb)

T2: 140 N.m (14.3 kgf-m, 103.3 ft-lb)

Fig 2: Front And Rear Crossmember Mounting Bolts With Torque Specifications
Courtesy of SUBARU OF AMERICA, INC.
Remove the transmission jack.
Install the heat shield cover. Refer to INSTALLATION .
Install the front and center exhaust pipe. Refer to INSTALLATION and INSTALLATION .
Install the front under cover. Refer to INSTALLATION .
Lower the vehicle.
Connect the battery ground terminal.