Bevel Pinion Gear Backlash

WARNING: This page is about a different variant/trim than selected.

Measure the backlash between the differential bevel gear and differential bevel pinion. Adjust the backlash if not within specified limit. Refer to ADJUSTMENT .

Standard backlash

0.13 - 0.18 mm (0.0051 - 0.0071 in)

ST1 498247001 MAGNET BASE

ST2 498247100 DIAL GAUGE

Fig 1: Measuring Backlash Between Differential Bevel Gear And Pinion Using Special Tools

Courtesy of SUBARU OF AMERICA, INC.