Clutch Pedal: Disassembly

WARNING: This page is about a different variant/trim than selected.

Disconnect the clutch pipe from the master cylinder.

Fig 1: Locating Clutch Pipe Nuts
Courtesy of SUBARU OF AMERICA, INC.
Remove the clutch damper mounting nut from the pedal assembly, and disconnect the clutch pipe from the clamp.

Fig 2: Locating Clutch Damper Mounting Nut And Clamp
Courtesy of SUBARU OF AMERICA, INC.
Remove the clutch switches.
Remove the clip and pull out the clevis pin.

Fig 3: Identifying Clip And Clevis Pin
Courtesy of SUBARU OF AMERICA, INC.
Disconnect the connector from the clutch stroke sensor, and then remove the sensor harness.
Remove the master cylinder from the pedal assembly.
NOTE: Secure the push rod with a tape etc. to prevent it from falling off.

Fig 4: Locating Master Cylinder Nuts
Courtesy of SUBARU OF AMERICA, INC.
Remove the torsion spring and assist bushing from the pedal assembly.

Fig 5: Identifying Torsion Spring And Assist Bushing
Courtesy of SUBARU OF AMERICA, INC.
Remove the clutch pedal from the pedal bracket.

Fig 6: Identifying Clutch Pedal
Courtesy of SUBARU OF AMERICA, INC.
Remove the bushing, spacer, bushing A, stopper, torsion spring bushing and clutch pedal pad from the clutch pedal.

Fig 7: Identifying Bushing, Spacer, Bushing A, Stopper, Torsion Spring Bushing, Clutch Pedal Pad And Clutch Pedal
Courtesy of SUBARU OF AMERICA, INC.