LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Legacy Premium, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Fuel Injection System (H6DO)) >> Oil Flow Control Solenoid Valve >> Removal >> Exhaust Side

Exhaust Side

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the ground cable from battery.
  2. Lift up the vehicle.
  3. Remove the under cover. Refer to REMOVAL .
  4. Disconnect the connector from the exhaust oil flow control solenoid valve LH.
    Fig 1: Locating Exhaust Oil Flow Control Solenoid Valve LH Connector
    G05667604Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the exhaust oil flow control solenoid valve LH.
    Fig 2: Locating Exhaust Oil Flow Control Solenoid Valve LH
    G05667605Courtesy of SUBARU OF AMERICA, INC.
  6. Remove the exhaust oil flow control solenoid valve RH in the same procedure as the exhaust oil flow control solenoid valve LH.
scientia non olet · About LEMON Manuals