LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Legacy Premium, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Fuel Injection System (H6DO)) >> Fuel >> Procedure >> Draining Fuel (Through The Fuel Filler Hose)

Draining Fuel (Through The Fuel Filler Hose)

WARNING: This page is about a different variant/trim than selected.
WARNING: Place "NO OPEN FLAMES" signs near the working area.
CAUTION:
  • Be careful not to spill fuel.
  • Fuel may remain in the fuel filler pipe. Draining the fuel from the fuel filler pipe through the fill opening using the gasoline proof pump and the gasoline proof hose (ø10 or less) before the operation.
  1. Lift up the vehicle.
  2. Remove the rear exhaust pipe and muffler. Refer to REMOVAL and REMOVAL .
  3. Open the fuel filler lid and remove the fuel filler cap.
  4. Drain the fuel from the fuel filler pipe through the filler opening using the gasoline proof pump and the gasoline proof hose (ø10 or less).
  5. Disconnect the fuel filler hoses from the fuel filler pipe.
    CAUTION:
    • Be careful not to spill fuel.
    • Catch the fuel from hoses using a container or cloth.
      Fig 1: Locating Fuel Filler Hose Clamp
      G06648362Courtesy of SUBARU OF AMERICA, INC.
  6. Set the container under the vehicle and insert the gasoline proof hose (ø10 or less) into the fuel filler hose to drain the fuel.
    CAUTION: Be careful not to spill fuel.
  7. Install the related parts in the reverse order after draining the fuel.

    Tightening torque: 

    2.5 N.m (0.3 kgf-m, 1.8 ft-lb) 

    Fig 2: Identifying Fuel Filler Pipe, Hose, Clamp And Spool
    G08581054Courtesy of SUBARU OF AMERICA, INC.