LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Legacy Premium, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Fuel Injection System (H6DO)) >> Camshaft Position Sensor >> Removal >> Exhaust Side

Exhaust Side

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the ground cable from battery.
  2. Lift up the vehicle.
  3. Remove the under cover. Refer to REMOVAL .
  4. Disconnect the connector from exhaust camshaft position sensor LH.
    Fig 1: Locating Exhaust Camshaft Position Sensor LH Connector
    G05667584Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the exhaust camshaft position sensor LH.
    Fig 2: Locating Exhaust Camshaft Position Sensor LH
    G05667585Courtesy of SUBARU OF AMERICA, INC.
  6. Remove the exhaust camshaft position sensor RH in the same procedure as LH side.
scientia non olet · About LEMON Manuals