Section 4 (Engine Mechanical (H6DO)): V-belt: Removal

WARNING: This page is about a different variant/trim than selected.

Remove the collector cover.
NOTE: Follow the steps below when removing the collector cover.
1. Pull up the two points at the rear (A).
2. Pull up the two points at the front (B) while moving them forward.
  
  Fig 1: Removing Collector Cover
  Courtesy of SUBARU OF AMERICA, INC.
Remove the air intake duct. Refer to REMOVAL .
Install the tool to the pulley bolt of the belt tension adjuster assembly.
Rotate the tool clockwise and loosen the V-belt to remove.

Fig 2: Loosening V-Belt
Courtesy of SUBARU OF AMERICA, INC.