Preparation for Overhaul: Removal

WARNING: This page is about a different variant/trim than selected.

Remove the engine from vehicle. Refer to REMOVAL .
Set the engine on ST.
ST 18232AA000 ENGINE STAND

Fig 1: Identifying Engine Supported On Stand
Courtesy of SUBARU OF AMERICA, INC.
Before servicing overhaul, remove the sensor, pipe and hose that installed to engine.
1. Remove the intake manifold. Refer to REMOVAL .
2. Remove the generator. Refer to REMOVAL .
3. Remove the A/C compressor. Refer to REMOVAL .
4. Disconnect the water pipe and hose.
5. Disconnect the engine harness.
6. Remove the spark plug. Refer to REMOVAL .
7. Remove the camshaft position sensor. Refer to REMOVAL .
8. Remove the crankshaft position sensor. Refer to REMOVAL .
9. Remove the knock sensor. Refer to REMOVAL .
10. Remove the engine coolant temperature sensor. Refer to REMOVAL .
11. Remove the oil temperature sensor. Refer to REMOVAL .
12. Remove the oil flow control solenoid valve. Refer to REMOVAL .
13. Remove the oil pressure switch. Refer to REMOVAL .
14. Remove the oil filter. Refer to REMOVAL .
15. Remove the oil cooler. Refer to REMOVAL .