Piston Ring

WARNING: This page is about a different variant/trim than selected.

If the piston ring is broken, damaged or worn, or if its tension is insufficient, or when the piston is replaced, replace the piston ring with a new part of the same size as piston.
NOTE:
- The top ring and second ring have the mark to determine the direction for installing. When installing the ring to piston, face marks to the top side.
- Oil ring consists of the upper rail, expander and lower rail. When installing to the piston, be careful of the direction of each rail.
Fig 1: Identifying Top, Second And Oil Ring, Upper And Lower Rail, Expander
Courtesy of SUBARU OF AMERICA, INC.

Squarely place the piston ring and oil ring in cylinder, and measure the piston ring gap with a thickness gauge.

		Standard mm (in)
Piston ring gap	Top ring	0.20 - 0.35 (0.0079 - 0.0138)
	Second ring	0.40 - 0.50 (0.0157 - 0.0197)
	Oil ring	0.20 - 0.50 (0.0079 - 0.0197)

Fig 2: Measuring Piston Ring Gap Using Thickness Gauge

Courtesy of SUBARU OF AMERICA, INC.

Fit the piston ring straight into the piston ring groove, then measure the clearance between piston ring and piston ring groove with a thickness gauge.

NOTE: Before measuring the clearance, clean the piston ring groove and piston ring.

		Standard mm (in)
Clearance between piston ring and piston ring groove	Top ring	0.040 - 0.080 (0.0016 - 0.0031)
Clearance between piston ring and piston ring groove	Second ring	0.030 - 0.070 (0.0012 - 0.0028)
Clearance between oil ring and oil ring groove		0.065 - 0.165 (0.0026 - 0.0065)

Fig 3: Measuring Clearance Between Piston Ring And Groove Using Thickness Gauge

Courtesy of SUBARU OF AMERICA, INC.