LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Legacy Premium, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Automatic Transmission - Diagnostics) >> Diagnostic Procedure without Diagnostic Trouble Code (DTC) >> Check Shift Indicator >> Trouble Symptom

Check Shift Indicator: Trouble Symptom

WARNING: This page is about a different variant/trim than selected.
DIAGNOSTIC PROCEDURE

Step Check Yes No
1 CHECK TCM. 
Check the DTC relating the TCM using the Subaru Select Monitor.		 Is DTC displayed? Perform the diagnosis according to DTC. Go to step 2  .
2 CHECK COMBINATION METER. 
Check the DTC of combination meter.		 Is DTC displayed? Perform the diagnosis according to DTC. Go to step 3  .
3 CHECK TCM. 
  1. Turn the ignition switch to OFF.
  2. Connect the Subaru Select Monitor to data link connector.
  3. Turn the ignition switch to ON.
  4. Run the Subaru Select Monitor.
  5. Shift the select lever to manual mode.
  6. Read the data of «Gear Position» using Subaru Select Monitor.
 Is the gear position "1"? Go to step 4  . Replace the TCM. Refer to TRANSMISSION CONTROL MODULE (TCM) .
4 CHECK TCM. 
  1. Shift up the select lever.
  2. Read the data of «Gear Position» using Subaru Select Monitor.
 Is the gear position "2"? Replace the combination meter assembly. Refer to COMBINATION METER . Replace the TCM. Refer to TRANSMISSION CONTROL MODULE (TCM) .
scientia non olet · About LEMON Manuals