LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Legacy Premium, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Automatic Transmission - Diagnostics) >> Diagnostic Procedure with Diagnostic Trouble Code (DTC) >> DTC P1724 At EEPROM Error >> Trouble Symptom

DTC P1724 At EEPROM Error: Trouble Symptom

WARNING: This page is about a different variant/trim than selected.
DIAGNOSTIC PROCEDURE

Step Check Yes No
1 CHECK BATTERY. 
  1. Turn the ignition switch to ON.
  2. Read the data of «Battery voltage» using Subaru Select Monitor.
 Is the «Battery voltage» 10 V or more? Go to step 2  . Check the battery.
2 CHECK DTC. 
  1. Turn the ignition switch to OFF.
  2. Turn the ignition switch to ON after one minute.
 Is DTC P1724 displayed as a temporary code? Replace the TCM. Refer to TRANSMISSION CONTROL MODULE (TCM) . Current condition is normal. Check for poor contact of TCM connector or harness.
scientia non olet · About LEMON Manuals