LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Legacy Premium, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Automatic Transmission - Diagnostics) >> AT OIL TEMP Warning Light Display >> Inspection >> Trouble Symptom

AT OIL TEMP Warning Light Display: Inspection: Trouble Symptom

WARNING: This page is about a different variant/trim than selected.
Step Check Yes No
1 CHECK AT OIL TEMP LIGHT. 
Turn the ignition switch to ON.
Does the AT OIL TEMP light illuminate? Go to step . Perform the self-diagnosis of combination meter. Refer to SELF-DIAGNOSIS DISPLAY MODE .
2 CHECK AT OIL TEMP LIGHT. 
After the ignition switch is ON, wait for 2 seconds or more.
Does the AT OIL TEMP light illuminate? Go to step . Go to step .
3 CHECK AT OIL TEMP LIGHT. 
Start the engine.
Does the AT OIL TEMP light go off? Normal. Go back to Basic Diagnostic Procedure. Refer to BASIC DIAGNOSTIC PROCEDURE . Go to step .
4 CHECK SUBARU SELECT MONITOR COMMUNICATION. 
Connect the Subaru Select Monitor to data link connector.
Is the communication between Subaru Select Monitor and TCM normal? Go to step . Check the power supply ground circuit of TCM and Subaru Select Monitor communication. Refer to DIAGNOSTIC PROCEDURE FOR SUBARU SELECT MONITOR COMMUNICATION .
5 CHECK DTC. 
Read the DTC relating the TCM using the Subaru Select Monitor.
Is DTC displayed? Perform the diagnosis according to DTC. Go to step .
6 CHECK TCM. 
Read the data of «ATF Temperature Lamp» using the Subaru Select Monitor.
Is "ON" displayed? Go to step . Perform the self-diagnosis of combination meter. Refer to SELF-DIAGNOSIS DISPLAY MODE .
7 CHECK TCM. 
Read the data of «ATF Temp.» using the Subaru Select Monitor.
Is the display 130°C or more? Go to step . Replace the TCM. Refer to TRANSMISSION CONTROL MODULE (TCM) .
8 CHECK ATF TEMPERATURE. 
Check the real fluid temperature from the transmission case surface temperature.
Is the temperature lower than «ATF Temp.» displayed on Subaru Select Monitor? Perform the diagnosis according to DTC P0713. When ATF temperature can be judged as actually high, perform the diagnosis again after the ATF temperature lowers.