Enable Conditions
WARNING: This page is about a different variant/trim than selected.
ENABLE CONDITIONS
| Secondary Parameters | Enable Conditions |
|---|---|
| Battery voltage | > 10.9 V |
| Atmospheric pressure | > 75 kPa (563 mmHg, 22.2 inHg) |
| A/F main learning system | In operation |
| Engine speed | > 500 rpm |
| Engine coolant temperature | > 75 °C (167 °F) (Except for C6 model) |
| > 200 °C (392 °F) (C6 model) | |
| Intake air temperature | < 70 °C (158 °F) |
| Engine load | > Value of Map 1 |
| Engine load change | < 0.02 g/rev (0 oz/rev) |
| Evaporative system leak check | Not in operation |
| Cumulative time of canister purge after engine start | ≥ 20.48 s |
| Learning value of EVAP conc. | < 0.07 |
| Vehicle dynamic control or AT torque control | Not in operation |
| Intake manifold pressure change at 120°CA | < Value of Map 2 |
| Throttle position change during 16 milliseconds | < 20 ° |
| Fuel shut-off function | Not in operation |
MAP 1
| Engine speed (rpm) | Idling | 700 | 1000 | 1500 | 2000 | 2500 | 3000 | 3500 | 4000 | 4500 | 5000 |
| Measured value (g (oz)/rev) | na | 0.357 (0.01) | 0.25 (0.01) | 0.25 (0.01) | 0.317 (0.01) | 0.326 (0.01) | 0.337 (0.01) | 0.397 (0.01) | 0.439 (0.02) | 0.454 (0.02) | 0.454 (0.02) |
MAP 2
| rpm | 700 | 1000 | 1500 | 2000 | 2500 | 3000 | 3500 | 4000 |
| kPa (mmHg, inHg) | 20 (150, 5.9) | 20 (150, 5.9) | 20 (150, 5.9) | 20 (150, 5.9) | 20 (150, 5.9) | 20 (150, 5.9) | 20 (150, 5.9) | 20 (150, 5.9) |
ENABLE CONDITIONS
| rpm | 4500 | 5000 | 5500 | 6000 | 6500 | 7000 |
| kPa (mmHg, inHg) | 20 (150, 5.9) | 20 (150, 5.9) | 20 (150, 5.9) | 20 (150, 5.9) | 20 (150, 5.9) | 20 (150, 5.9) |