Purge Control Solenoid Valve

WARNING: This page is about a different variant/trim than selected.

Check that the purge control solenoid valve has no deformation, cracks or other damages.

Measure the resistance between the purge control solenoid valve terminals.

Fig 1: Measuring Resistance Between Purge Control Solenoid Valve Terminals

Courtesy of SUBARU OF AMERICA, INC.

	Terminal No.	Standard
Purge control solenoid valve	1 and 2	32±3 Ω (when 20°C (68°F))

Check that air does not come out from (B) when air is blown into (A).

Fig 2: Inspecting For Air Leaks
Courtesy of SUBARU OF AMERICA, INC.
Connect the battery positive terminal to the terminal No. 1 and the battery negative terminal to the terminal No. 2. Check that air is discharged from (B), when supplying air to (A).

Fig 3: Connecting Battery Positive Terminal To Terminal No. 1 And Battery Negative Terminal To Terminal No. 2
Courtesy of SUBARU OF AMERICA, INC.