LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Legacy Premium, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Engine Controls (Diagnostics) (H6DO)) >> Drive Cycle >> Procedure >> Drive Cycle J >> Diagnostic procedure

Diagnostic procedure

WARNING: This page is about a different variant/trim than selected.
  1. Idle the engine for 15 minutes or more.
  2. Turn the ignition switch to OFF.
  3. After 10 hours passed from the start of step  2), read the pending code using the Subaru Select Monitor. Refer to OPERATION .
scientia non olet · About LEMON Manuals