DTC P0336: Crankshaft Position Sensor "A" Circuit Range/Performance: Trouble Symptom
WARNING: This page is about a different variant/trim than selected.
- Engine stalls.
- Failure of engine to start
CAUTION:
After servicing or replacing faulty parts, perform Clear Memory Mode and Inspection Mode. Refer to
OPERATION and
PROCEDURE .
DIAGNOSTIC PROCEDURE
| Step | Check | Yes | No |
|---|---|---|---|
| 1 CHECK CONDITION OF CRANKSHAFT POSITION SENSOR. Turn the ignition switch to OFF. |
Is the crankshaft position sensor installation bolt tightened securely? | Go to step 2 . | Tighten the crankshaft position sensor installation bolt securely. Refer to INSTALLATION . |
| 2 CHECK CRANKSHAFT PLATE. | Is there crack or damage in the crankshaft plate teeth? | Replace the crankshaft plate. | Go to step 3 . |
| 3 CHECK INSTALLATION CONDITION OF TIMING CHAIN. Turn the crankshaft, and align alignment mark on crank sprocket with alignment mark on cylinder block. ST 18252AA000 CRANKSHAFT SOCKET |
Is the timing chain dislocated from its proper position? | Correct the installation condition of timing chain. Refer to TIMING CHAIN ASSEMBLY . | Replace the crankshaft position sensor. Refer to CRANKSHAFT POSITION SENSOR . |