LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Legacy Premium, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Automatic Transaxle) >> Air Breather Hose >> Removal

Air Breather Hose: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the collector cover.
    NOTE: Follow the steps below when removing the collector cover.
    1. Pull up the two points at the rear (A).
    2. Pull up the two points at the front (B) while moving them forward.
      Fig 1: Removing Collector Cover
      G06651504Courtesy of SUBARU OF AMERICA, INC.
  2. Remove the air intake boot. Refer to REMOVAL .
  3. Remove the air breather hose.
    Fig 2: Identifying Air Breather Hose
    G06652034Courtesy of SUBARU OF AMERICA, INC.