High & Low Reverse Clutch Assembly

WARNING: This page is about a different variant/trim than selected.

Check the clearance of the high & low reverse clutch
Measure the clearance "L" between snap ring and retaining plate using a thickness gauge. If it is out of specification, replace the entire high & low reverse clutch assembly.
Check for damage on the drive plate, driven plate and snap ring, and replace the entire high & low reverse clutch assembly if damaged.
Standard:

1.8 - 2.2 mm (0.071 - 0.087 in)

Fig 1: Identifying High & Low Reverse Clutch Assembly Clearance
Courtesy of SUBARU OF AMERICA, INC.