LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Legacy Premium, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (Starting System & Charging System (H4DO)) >> Generator >> Inspection >> Stator Coil

Stator Coil

WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
  1. Continuity test

    Inspect the continuity between the stator coil terminals. If continuity is not as shown in the table, replace the stator coil.

    Fig 1: Stator Coil Continuity Chart
    G08570357Courtesy of SUBARU OF AMERICA, INC.
    Fig 2: Inspecting Continuity Between Stator Coil Terminals
    G07665198Courtesy of SUBARU OF AMERICA, INC.
  2. Insulation test

    Inspect the continuity between the stator coil stator core and lead wire terminals. If there is continuity, replace the stator coil because the stator coil is grounded.

    Fig 3: Inspecting Continuity Between Stator Coil Stator Core And Lead Wire Terminals
    G07665199Courtesy of SUBARU OF AMERICA, INC.