Check Cruise Indicator Light And Cruise Set Indicator Light: Trouble Symptom

WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

Cruise control can be set, but the cruise indicator light and cruise set indicator light do not illuminate.

Step	Check	Yes	No
1 CHECK CRUISE INDICATOR LIGHT AND CRUISE SET INDICATOR LIGHT. Perform the self-diagnosis of combination meter.< Refer to SELF-DIAGNOSIS , INSPECTION, Combination Meter System. > Check the cruise indicator light and cruise set indicator light if they illuminate.	Do the cruise indicator light and cruise set indicator light illuminate?	Go to step 2 .	Replace the meter case assembly.< Refer to COMBINATION METER . >
2 CHECK DTC OF LAN COMMUNICATION CIRCUIT. Complete self-diagnosis, and turn the ignition switch to ON again. Read the DTC of body integrated unit using Subaru Select Monitor.	Is DTC of low-speed CAN displayed?	Check the LAN communication circuit.< Refer to BASIC DIAGNOSTIC PROCEDURE . >	Replace the ECM. < Refer to ENGINE CONTROL MODULE (ECM) . >