LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Legacy Premium, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 59 (Window Glass & Mirrors) >> Wiper Deicer System >> Inspection >> System Inspection

System Inspection

WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • The wiper deicer does not operate when the ambient temperature becomes 5°C (41°F) or more.
  • The wiper deicer operates with the rear window defogger at the same time.
  • It is possible to perform a forced operation if you keep holding the rear window defogger switch for 3 seconds or more.
Symptoms Inspection order
Wiper deicer does not operate.
  1. Check the fuse.
  2. Check the wiper deicer relay.
  3. Check the rear defogger switch.
  4. Check the heat wire.
  5. Check the wiring harness.
  6. Check body integrated unit.
NOTE:
  • Wiper deicer system can be customized using the Subaru Select Monitor, when the customize setting {A/C ECM setting} of the body integrated unit is set to With. (auto A/C model)
  • Set the system using the Rr Defogger op. mode, and setting will be the same as rear defogger system setting.
System name Initial setting Customize setting
Rear defogger operation mode OFF after 15 min. Continuous operation(1)
(1) When one of the following conditions occurs, continuous operation is suspended and turned off after 15 minutes.